10 July 2009

Monocoque from single list definitions

This is a simple example of a monocoque generated from points on a surface. With just a few components, sixteen points are inputted to draw an interpolated curve on the surface. This was done before the implementation of data-trees in Grasshopper, so, from a single list of points a zigzag curve is drawn. In order to have two directions to work structurally, the sixteen points are inputted once again, resembling the other order needed.

In general, single list have been seen as a limitation when working with surface sub-parameters, but in this case I was taking advantage of them to get this aesthetic output.

2 comments: